This is the 1/10 scale glow powered, radio controlled, ready to run HPI Nitro RS4 3 Evo+ with the 1967 Corvette Coupe Body. FEATURES: Chassis: 0.098" (2.5mm) 6061 aluminum, gray in color Drive: Four wheel shaft drive Engine: Nitro Star G3.0 3.0cc (.18 cu in) 2.2hp with Roto-Start can be bump started in racing applications) ABC cylinder and line construction-"A"luminum piston,"B"rass cylinder liner that is "C"hrome plated, lightweight aluminum con rod, 2 needle 6.5mmrotary carburetor, 2 stage air filter Exhaust: Dual chamber aluminum tuned pipe, black in color Radio: 2.4GHz 3-channel with steering and throttle trims, dual rate for steering and charge jack for optional NiCd battery Servos: Two standard size and torque Fuel Tank: 2.53oz (75cc), flip top cap Clutch: 2-shoe Transmission: Two-speed, adjustable Ball Bearings: 18 rubber sealed Shocks: Four oil-filled, with coil-over spring Main Gear: 47 and 43 tooth composite construction main gears Clutch bell: 22 teeth and 18 teeth gears that thread onto clutch Gearbox: Sealed, front and rear Differentials: Sealed, with metal bevel gears, limited slip front differentialBrake: Single disc, fiber construction Tires: D compound X-pattern 1.02" (26mm) wide, 2.5" (65mm) diameterWheels: Vintage 5-spoke matte finish chrome 6-Cell Flat Battery Pack: 7.2V 2000mAh for Roto Start Battery Charger: Wall type for Roto Start battery Fuel Bottle: 8.4oz (250cc) Glow Starter: C size with C-cell battery included Body: Pre-painted and trimmed Bumper: Front foam Suspension: Four wheel independent double wishbone Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering: Bellcrank Servo Saver: Included